TP-LINK 2.4GHz 300Mbps / CPE210 - Speeds Slow Over Hours/Days until depowering Client CPE
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-LINK 2.4GHz 300Mbps / CPE210 - Speeds Slow Over Hours/Days until depowering Client CPE
Hi,
My setup:
- Medialink AC1200 Router (MLWR-AC1200R) ----->
- TP-Link 2.4GHz N300 Long Range Outdoor CPE (CPE210) ----->
- (About 50 feet of clear, outdoor space) ----->
- TP-Link 2.4GHz N300 Long Range Outdoor CPE (CPE210) ----->
- Medialink AC1200 Router (MLWR-AC1200R)
This had worked great for over a year, but in the past month the following takes place on the client side:
- A speed test shows 60Mbps+
- A few hours/days go by and the speed drops to <1Mbps
Troubleshooting. From what I can tell....:
- Running an Ethernet cable directly from the CPE power adapter to a computer (and thus skipping the router) does not improve the speed.
- Powering the router off/on does not help.
- Unplugging/plugging the ethernet cable between the router and CPE210 does not help
- Unplugging/plugging the ethernet between the CPE and the CPE power supply does not help
- Running a cable from the router to a computer does not increase speeds
- Unplugging/plugging the power supply for the CPE brings the speeds back to 60Mbps+ for the next few hours/days
Again, no recent changes from a hardware/end user behavior/settings perspective. Any thoughts?
Thanks
Re:TP-LINK 2.4GHz 300Mbps / CPE210 - Speeds Slow Over Hours/Days until depowering Client CPE
Any thoughts? Painfully slow before unplugging the CPE210 client device. Tests below show speeds before and after briefly unplugging the either net cable that runs between the CPE and the power block/adapter. 😓
