Business Community > All Threads > [SG2210P 4.0] set "ip management-vlan xxx"
< All Threads

[SG2210P 4.0] set "ip management-vlan xxx"

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

[SG2210P 4.0] set "ip management-vlan xxx"

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
[SG2210P 4.0] set "ip management-vlan xxx"
[SG2210P 4.0] set "ip management-vlan xxx"
2021-12-27 11:32:57
Model: SG2210P  
Hardware Version: V4
Firmware Version: newest

Hello,

How can I set the default vLAN for switch management? According to the CLI documentation the following command should be available, but it is not.

ip management-vlan xxx

 

When I remove the default network under L3 Interface, I only get to the switch from the default gateway, not from other subnets....

 

Thanks for Tips

 

ps. in other "T1500G-10PS 2.0" Switch is this very simple

  0      
 
  0      
 
#1
Options
2 Reply
Re:[SG2210P 4.0] set "ip management-vlan xxx"
2021-12-27 12:35:05 - last edited 2021-12-27 12:38:17

ok, my goal is reached.

 

I can now reach the Managament vLAN from all other subnets.
(Provided the firewall(10.8.250.1) allows this access).

 

Settings on the switch: (HVM-Management vLAN to Firewall-IP)

ip route 0.0.0.0 0.0.0 10.8.250.1

 

and disable Routing over GUI:

L3 Features\Interface\Routing Config -> Unchecked IPv4 routing

 

and:

L3 Features\Interface\Interface Config -> VLAN-ID DHCP 10.8.250.12 255.255.0 HVM Up

 

  0  
  0  
#2
Options
Re:[SG2210P 4.0] set "ip management-vlan xxx"
2021-12-30 03:21:01

Dear @Simon74,

 

Simon74 wrote

How can I set the default vLAN for switch management? According to the CLI documentation the following command should be available, but it is not.

ip management-vlan xxx

 

When I remove the default network under L3 Interface, I only get to the switch from the default gateway, not from other subnets....

 

The command "ip management-vlan" is only available for older version.

 

For TL-SG2210P v3.20 and later version, you may use the command "user access-control" instead. 

Check this CLI Guide for your TL-SG2210P v4 to get more details. Hope it helps.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 885

Replies: 2

Related Articles
No IP Settings SG2210P v3.20
1648 0
TL-SG2210P VLAN setup.
1564 0
updated SG2210P?
353 0
Can´t set Management Vlan
2582 0
TL-SG2210P - Setup with PFSense and VLAN
1701 0
SG2210P LAG LACP ?
850 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.