POE powered Switch or not? "TL-SG2008" No Power Adapter

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

POE powered Switch or not? "TL-SG2008" No Power Adapter

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
POE powered Switch or not? "TL-SG2008" No Power Adapter
POE powered Switch or not? "TL-SG2008" No Power Adapter
2021-11-05 11:54:07 - last edited 2021-11-29 01:48:49
Model: SG2008P  
Hardware Version:
Firmware Version:

Hi,

 

Does TP-Link have any POE powered switches that don't need any power adapters?
Like small 5-8 ports? and Omada compatible if possible. Have looked but uncertain of the data in the spec.

Thanks

  0      
  0      
#1
Options
2 Accepted Solutions
Re:POE powered Switch - No power adapter?-Solution
2021-11-05 14:34:35 - last edited 2021-11-29 01:50:54

@HA4g3n 

Yes the TL-SG2008 has a PD input port. Its a great feature and you would think it would be advertised more.

Specs are here:
https://www.tp-link.com/ca/business-networking/omada-sdn-switch/tl-sg2008/#specifications

Under "Power Supply" - Obtain Power from PoE Source

Plus I have seen with my own eyes lol

Recommended Solution
  1  
  1  
#2
Options
Re:POE powered Switch - No power adapter?-Solution
2021-11-12 02:34:11 - last edited 2021-11-29 01:55:05

Dear @HA4g3n,

 

HA4g3n wrote

Yes, i tried both port 1 and 8 and no luck but the cable is quite long so i just tried for fun and only bonus if it had worked.
Can you confirm the SE variant can be powered on the port 8 POE without a power supply?


Hardware information that OC Controller posts:
Model: TL-SG2008P v1.0

S/N : 22121F0001154
Firmware Version : 1.0.2 Build 20210806 Rel.55686

 

 Kind note that TL-SG2008P is a different model from TL-SG2008.

 

The former is a PoE switch, it cannot work as a PD to be powered up via PoE, but can only power up other PDs.

The latter is a non-PoE switch, it can work as a PD to be powered up via PoE through the PD port (Port 8).

 

Edit:

TL-SG2008 V3 and above hardware version support Omada SDN.

TL-SG2008P V1 and above hardware version support Omada SDN.

 

For Omada Switches, you may check this link: https://www.tp-link.com/en/business-networking/all-omada/#omada-switch

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  1  
  1  
#8
Options
9 Reply
Re:POE powered Switch - No power adapter?-Solution
2021-11-05 14:34:35 - last edited 2021-11-29 01:50:54

@HA4g3n 

Yes the TL-SG2008 has a PD input port. Its a great feature and you would think it would be advertised more.

Specs are here:
https://www.tp-link.com/ca/business-networking/omada-sdn-switch/tl-sg2008/#specifications

Under "Power Supply" - Obtain Power from PoE Source

Plus I have seen with my own eyes lol

Recommended Solution
  1  
  1  
#2
Options
Re:POE powered Switch - No power adapter?
2021-11-06 10:03:49 - last edited 2021-11-07 09:14:24

@EIBROG 

Thanks, yes agreed! should be adverticed alot more! :) 
 

Power Supply • 12 VDC/1 A External Adapter or
• Obtain Power from PoE Source
 


I actually have installed this one at a customer and the POE source did not work as a power source and the reason for that is the length of the cable i guess. It's longer then 50-60meters so it was a "long"shot.
Thank will use these more.


EDIT:
Actually the reason i ask is because the information of the device is different once again depending on the region you read about it. I guess this feature is not available in the Swedish version?

CA version --> https://www.tp-link.com/se/business-networking/omada-sdn-switch/tl-sg2008p/v1/#specifications

Power Supply • 12 VDC/1 A External Adapter or
• Obtain Power from PoE Source



SE Version: https://www.tp-link.com/se/business-networking/omada-sdn-switch/tl-sg2008p/v1/#specifications

Power Supply • External Power Adapter (Output: 53.5 VDC/ 1.31 A)

 

  0  
  0  
#3
Options
Re:POE powered Switch - No power adapter?
2021-11-08 15:07:22

@HA4g3n 

oh wow - yeah they should have a model that explicitly has it and no regional differences for the same model number.

  1  
  1  
#4
Options
Re:POE powered Switch - No power adapter?
2021-11-09 21:00:08 - last edited 2021-11-10 17:58:05

Could @Fae  have an answer on this one maybe? :)

 

 

  0  
  0  
#5
Options
Re:POE powered Switch - No power adapter?
2021-11-11 01:46:00

Dear @HA4g3n,

 

HA4g3n wrote

EDIT:
Actually the reason i ask is because the information of the device is different once again depending on the region you read about it. I guess this feature is not available in the Swedish version?

CA version --> https://www.tp-link.com/se/business-networking/omada-sdn-switch/tl-sg2008p/v1/#specifications

Power Supply • 12 VDC/1 A External Adapter or
• Obtain Power from PoE Source


SE Version: https://www.tp-link.com/se/business-networking/omada-sdn-switch/tl-sg2008p/v1/#specifications

Power Supply • External Power Adapter (Output: 53.5 VDC/ 1.31 A)


The information on the Sweden TP-Link website may be incorrect, I'll report this to the website team to check and correct it.

https://www.tp-link.com/se/business-networking/smart-switch/tl-sg2008/#specifications

The link you attached above is for TL-SG2008P rather than TL-SG2008, by the way.

 

I actually have installed this one at a customer and the POE source did not work as a power source and the reason for that is the length of the cable i guess. It's longer then 50-60meters so it was a "long"shot.

 

As you mentioned that you have installed this one, may I confirm the model number and hardware version of the switch you installed?

Do you connect the power source and the switch via the PD port (Port 8) on the switch?

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  1  
  1  
#6
Options
Re:POE powered Switch - No power adapter?
2021-11-11 12:17:33 - last edited 2021-11-11 12:45:41

Hi @Fae 

Thank you for that :)


Yes, i tried both port 1 and 8 and no luck but the cable is quite long so i just tried for fun and only bonus if it had worked.
Can you confirm the SE variant can be powered on the port 8 POE without a power supply?


Hardware information that OC Controller posts:
Model: TL-SG2008P v1.0

S/N : 22121F0001154
Firmware Version : 1.0.2 Build 20210806 Rel.55686


Kind Regards


 
  0  
  0  
#7
Options
Re:POE powered Switch - No power adapter?-Solution
2021-11-12 02:34:11 - last edited 2021-11-29 01:55:05

Dear @HA4g3n,

 

HA4g3n wrote

Yes, i tried both port 1 and 8 and no luck but the cable is quite long so i just tried for fun and only bonus if it had worked.
Can you confirm the SE variant can be powered on the port 8 POE without a power supply?


Hardware information that OC Controller posts:
Model: TL-SG2008P v1.0

S/N : 22121F0001154
Firmware Version : 1.0.2 Build 20210806 Rel.55686

 

 Kind note that TL-SG2008P is a different model from TL-SG2008.

 

The former is a PoE switch, it cannot work as a PD to be powered up via PoE, but can only power up other PDs.

The latter is a non-PoE switch, it can work as a PD to be powered up via PoE through the PD port (Port 8).

 

Edit:

TL-SG2008 V3 and above hardware version support Omada SDN.

TL-SG2008P V1 and above hardware version support Omada SDN.

 

For Omada Switches, you may check this link: https://www.tp-link.com/en/business-networking/all-omada/#omada-switch

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  1  
  1  
#8
Options
Re:POE powered Switch - No power adapter?
2021-11-28 13:56:55

@Fae 

ahh okey, so TL-SG2008 is a smart switch that does not support Omada and POE out but POE-in.

And TL-SG2008P is a smart switch that do supports POE+ out and Omada Cloud but cannot be powered by a POEin but just a power adapter.

Thanks for that verification.

  0  
  0  
#9
Options
Re:POE powered Switch - No power adapter?
2021-11-29 01:58:17

Dear @HA4g3n,

 

HA4g3n wrote

ahh okey, so TL-SG2008 is a smart switch that does not support Omada and POE out but POE-in.

 

 

Not exactly, TL-SG2008 V3 and above hardware version support Omada SDN.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#10
Options

Information

Helpful: 0

Views: 3145

Replies: 9

Related Articles