EAP225 - Unable to Hard Reset via reset button
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have 2 eap225's,
suddenly one has stopped responding.
When the Router powers on the blink sequence goes like - green - red - yellow and then LED stays solid green.
There is no Wifi signal nor can I connect to it via ethernet.
checked on all ip's - 192.168.0.254 / 192.168.1.254 etc.
Tried to hard reset it, kept the Reset button pressed for a long time, then tried the 30 - 30 - 30 method, yet the green light remains solid, no blinks or resets.
Please assist.
Is there a way to hard reset via a jumper on the board, since the reset button is not responding?
Thank You
@Alikheri You need to disconnect the EAP from your router when you use a static IP, meaning only connect the computer to your EAP. did you do this? If this does not work, then I think you can consider contacting tplink to discuss the warranty.
@Alikheri You need to disconnect the EAP from your router when you use a static IP, meaning only connect the computer to your EAP. did you do this? If this does not work, then I think you can consider contacting tplink to discuss the warranty.