Bridge Mode break after LAN ports swapped with each other
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bridge Mode break after LAN ports swapped with each other
Region : Malaysia
Model : TL-WA7510N
Hardware Version : V1
Firmware Version :
ISP :
I set two TL-WA7510N as bridge mode connection. One of TL-WA7510N ( A ) connected to internet network and another (B) connected to my laptop. The connection is well connected as my laptop can access to internet.
However, after i swapped both LAN port connections where now A connected to my laptop and B connected to internet network. The bridge connection is disconnected. I need to restart both TL-WA7510N then the bridge connection is linked again. I do not where i done wrong in the setting.
I tested this situation using another two model which is TL-WA5120G. The bridge connection does not break after i swapped the LAN port connections.
Model : TL-WA7510N
Hardware Version : V1
Firmware Version :
ISP :
I set two TL-WA7510N as bridge mode connection. One of TL-WA7510N ( A ) connected to internet network and another (B) connected to my laptop. The connection is well connected as my laptop can access to internet.
However, after i swapped both LAN port connections where now A connected to my laptop and B connected to internet network. The bridge connection is disconnected. I need to restart both TL-WA7510N then the bridge connection is linked again. I do not where i done wrong in the setting.
I tested this situation using another two model which is TL-WA5120G. The bridge connection does not break after i swapped the LAN port connections.