Omada Hadrware Controller does not Boot after Upgrade
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi everybody,
I upgraded today my Omada OC200 Hardware Controller to the newest version.
After the upgrade the device is not pingable and i cant access the Webinterface. i alreday done a reboot but that doesent helped.
Did anyone have the same problem oder can help me to solve the problem?
Thank you!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Dear @Christian2705,
Christian2705 wrote
I upgraded today my Omada OC200 Hardware Controller to the newest version.
After the upgrade the device is not pingable and i cant access the Webinterface. i alreday done a reboot but that doesent helped.
Did anyone have the same problem oder can help me to solve the problem?
It seems that the OC200 is bricked, it's suggested to use the recovery mode to recover the firmware.
[Solution] How to use the Recovery Mode to recover the firmware for Omada Hardware Controller
Here is the download link for the new firmware of OC200: OC200_v1_1.9.1_Build 20210721
- Copy Link
- Report Inappropriate Content
Dear @Christian2705,
Christian2705 wrote
I upgraded today my Omada OC200 Hardware Controller to the newest version.
After the upgrade the device is not pingable and i cant access the Webinterface. i alreday done a reboot but that doesent helped.
Did anyone have the same problem oder can help me to solve the problem?
It seems that the OC200 is bricked, it's suggested to use the recovery mode to recover the firmware.
[Solution] How to use the Recovery Mode to recover the firmware for Omada Hardware Controller
Here is the download link for the new firmware of OC200: OC200_v1_1.9.1_Build 20210721
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi All,
I managed to recover and install previous firmware then install the latest firmware. Maybe this will help someone else.
What I did in steps-
I reset/recovery then reinstalled latest firmware --- no joy, no web interface response on 192.168.0.253
I reset/recovery then reinstalled previous firmware- It came up but when it got to end of update and startup the web interface failed so one more time.
I reset/recovery did factory restore- reboot. .. still no interface so...
I reset/recovery then reinstalled previous firmware- It came up fully. I skipped through setup and just added a login so I can try the update again.
I was then able to login and do a firmware upgrade to latest firmware.... whew finally :)
Did a site migration from the software client back to the oc200.
Currently everything is back up and running on latest firmware.
I cant say all of these steps were necessary but this is what I did and it finally got it to work.. mileage may very.... Good Luck.
Robert-
- Copy Link
- Report Inappropriate Content
@Fae The Controller crashed again on Update 4.4.6 need downlaod link to make a restore.....
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2099
Replies: 4
Voters 0
No one has voted for it yet.