TPLINK T1600G-28TS VLAN routing
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Thank you in advance for the help. I'm trying to run, at least right now, two VLANs and have them talk to each other through the Router. I'm running PSENSE and the TPLINK T1600G-28TS. I've setup my VLAN in PSENSE (see screenshots) with firewall rules to allow those interface to route anywhere.
On the switch in "VLAN CONFIG" all ports set to VLAN1 except 22, and on VLAN50 Port22 is set at PVID 50 and Port2=Router is set as tagged.
On the switch I have one computer(192.168.1.100) plugged into Port1(VLAN1) and the other computer(192.168.50.10) into Port22(VLAN50). I cant ping either one though. Shouldn't a ping leave the computerB(192.168.50.10) untagged, then get tagged by Port22 as VLAN50(S_VLAN) and travel to Router(VLAN aware) on PORT2(set as tagged VLAN50 port) which should send it to the S_VLAN interface with firewall rules that pass all traffic and end up at at computerA(192.168.1.100)?
I'm just trying to figure out this piece of the puzzle before I make something for complex.
