No Mesh between EAP225
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
No Mesh between EAP225
Hi,
I've recently installed 5 eap225 and 2 eap225-Outdoor and successfully mesh an eap225 to one of the outdoor without any problem through the Omada Controller.
I have another eap that I want to mesh with one of the wired eap225 indoor, but the controller never recognize that, even if put them very close.
I'm using the Omada Controller v.3.2.14, I've already tried to update both the EAP to every possible version but it never come up, I've also tried to mesh the same eap to the outdoor one and there it works, any suggestions?