VPN IPsec with 2Links Failover
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to conf TL-R605 to have Failover using IPsec VPN?
The idea is to have high availability on the TL-R605.
We have 2 internet providers on the router and an IPsec Lan-to-Lan VPN configured.
How to configure the router so that the VPN automatically connects using the backup link?
Thanks.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Dear @Assis,
Assis wrote
How to conf TL-R605 to have Failover using IPsec VPN?
The idea is to have high availability on the TL-R605.
We have 2 internet providers on the router and an IPsec Lan-to-Lan VPN configured.How to configure the router so that the VPN automatically connects using the backup link?
I'm afraid that the TP-Link router doesn't support Failover using IPSec VPN at present.
- Copy Link
- Report Inappropriate Content
Thanks.
This feature it will be appreciated.
The Ipsec software configuration don't need to set the output interface, but only the IP Address (WAN).
So I dont think this is a hard code to develop in a future release.
- Copy Link
- Report Inappropriate Content
Hi Guys,
Do you know if TPlink has any plans to develop a new version with VPN IPsec Failover?
We have 70 units of TL-R605 working with 2 internet link each. So, every time that primary internet fail we need to manually set the IPsec VPN configuration.
Its an unpleasent job for our technicians and a major problem to our customers.
Best Regards.
- Copy Link
- Report Inappropriate Content
Hi,
I have same problem with R605 site to site VPN backup. But what about some "semiautomatic" solution ? I have 2 ISP and 2 routers at both sides of the VPN tunnel and for me is no problem to switch some cables if one internet connection is down. But also cannot find the right setup....Can you help me we this ? Many thanks
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1491
Replies: 4
Voters 0
No one has voted for it yet.