R605 hardware version confusion
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Sticker on bottom of case clearly says Ver 1.6*, as does the sticker on the box. P/N: 0121600114
Web UI and Controller software both show it as version 1. In controller:
TRL-R605 v1.0 right next to EAP45(US) v3.0 with the firmware versions in the column over.
*I'll note the sticker seems to be a second layer on top of the original printed label, I haven't attempted to peel it off yet.
Is this "just" a mislabled unit? Shenanigans with reseller or something? (If anyone has info on differences between the hardware versions, that would be ideal.)
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@YATechMonkey same issue for me. starting a new thread too.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@YATechMonkey I returned the R605 yesterday and went back to my old router.
- The label on the equipment didn't match the ver. on 192.168.0.1
- HUGE ISSUE -- It kept dropping the internet in both standalone and when connected to Omada (could ping the router, but no internet)
- Couldn't determine how to set time-based access control individual network devices
- Standalone access didn't seem to work once adopted in Omada
- It appeared that firmware updates may only be applied via ip address in standalone mode, but it was difficult to access standalone mode after adopted in Omada,
- Copy Link
- Report Inappropriate Content
I upgraded to the "1.6" firmware, 1.0.1 Build 20210113 Rel.35074, without issue. The device now says I have hardware version: TL-R605 v1.0 and firmware version: 1.0.1 Build 20210113 Rel.35074. So far everything seems to be working fine.
- Copy Link
- Report Inappropriate Content
@redhed I did the same upgrade, but it kept dropping the www. (And why would an upgrade result in a ver. 1.0 when the label says 1.6?) Anyway, maybe I received a bad unit, but after about 6 hours of working with it, I just returned it.
- Copy Link
- Report Inappropriate Content
Dear @YATechMonkey,
YATechMonkey wrote
Sticker on bottom of case clearly says Ver 1.6*, as does the sticker on the box. P/N: 0121600114
Web UI and Controller software both show it as version 1. In controller:
TRL-R605 v1.0right next toEAP45(US) v3.0with the firmware versions in the column over.
V1.6 is usually sold in the US only, it's equal to V1.0.
- Copy Link
- Report Inappropriate Content
@Fae Thank you, yes it is very confusing between this:
And this:
Please consider updating the support/firmware download page to clarify.
- Copy Link
- Report Inappropriate Content
I have the same issue and I just unboxed the unit and connected in standalone mode. So should I upgrade the firmware corresponding to hardware version 1.0? Also, on the back label "US" clearly stands for United States, what does "UN" stand for? Thanks
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 4634
Replies: 8
Voters 0
No one has voted for it yet.