Omada Software controller Upgrade Advise
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada Software controller Upgrade Advise
Hello all,
I have a software Omada controller in version 3.2.1
My network is composed of EAP225V1 outdoors, 2 EAP245V1 and 1 EAP245V3
I'd like to add the 245V3 in my mesh network, but this requires a firmware upgrade.
firmware upgrade on the EAP245V3 requires new SDN controller 4.2.x
if however the upgrade to SDN 4.2 means I'll loose my two 245V1 EAPs - as they do not appear on the compat list.
Neither options seems good.
Got a few questions:
-Is it 100% guaranteed the 245v1 cannot be managed at all by the SDN 4.2?
-Can I run two SDN controllers on the same LAN? (note: my APs are on a different subnet than my SDN controller)
-Can I run two different SDN versions on the same linux box (CentOS)?
Any additional advice on how to best proceed?
