Business Community > All Threads > CPE210 setup - Extending my network but doesn't appear to be connecting to existing wifi
< All Threads

CPE210 setup - Extending my network but doesn't appear to be connecting to existing wifi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE210 setup - Extending my network but doesn't appear to be connecting to existing wifi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE210 setup - Extending my network but doesn't appear to be connecting to existing wifi
CPE210 setup - Extending my network but doesn't appear to be connecting to existing wifi
2021-01-09 18:03:02 - last edited 2021-01-11 02:55:17
Model: CPE210  
Hardware Version: V1
Firmware Version: 1.3.3 Build 20160526 Rel. 4923

Hello folks,

 

I am having trouble connecting my CPE to my existing wifi

 

I have successfully followed all of the steps in this support page to extend my existing home network  

 

On the dashboard it looks like everything is working as it should be with a strong signal coming through.

 

However it appears to be not connecting to the internet through my wifi.

 

Any thought as to what could be the issue? 

  0      
 
  0      
 
#1
Options
3 Reply
Re:CPE210 setup - Extending my network but doesn't appear to be connecting to existing wifi
2021-01-15 03:43:29

Dear @Eldridge,

 

You may refer to the guide below to install the CPE210.

https://www.tp-link.com/support/faq/2986/

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:CPE210 setup - Extending my network but doesn't appear to be connecting to existing wifi
2021-01-20 03:37:03

@Eldridge did you tried disabling the DHCP server on the CPE unit?

sometimes having DCHP enable on both the main router and the extender can cause problems

simply let the main router assign the addresses 

  1  
  1  
#3
Options
Re:CPE210 setup - Extending my network but doesn't appear to be connecting to existing wifi
2021-01-30 12:59:29

@antoniooninato When you say have I disabled DHCP I can confirm that it is switched off in the control panel

 

When I access the CPE 210 I go to networks on my mac - switch from DHCP to manual, input these to access the device control panel.

 

IP Address = 192.168.0.10

Sub mask = 255.255.255.0

Router = 192.168.0.254

 

 

 

I then switch back to DCHP in my network setting in order to access the internet

 

By doing this, is the CPE device switched to DCHP ?

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 972

Replies: 3

Related Articles
Extending wired network with 2 CPE210's
556 0
extending the network with the AP 225 outdoor.
329 0
Problem connecting CPE210 to EAP650 (or any AP)
220 0
CPE210 Setup Issues
5860 0
CPE210 will not "Lock to AP" which is another CPE210
1092 0
CPE210 client will not lock to CPE210 AP
1360 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.