Omada - Only show VLAN SSIDs on managed switches
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have just purchased this EAP235-Wall device to become part of a setup mixing EAP110, EAP115 and EAP225 devices.
I am using software controller v3.2.7 as the latest version supported by the oldest AP.
The EAP110 and EAP225 are connected to unmanaged switches, the EAP115 and the new EAP235-Wall are connected to managed switches.
If I add an SSID using a VLAN, it broadcasts across all APs, so there is no connectivity if clients connect to the VLAN SSID on APs connected to the unmanaged switches.
Does anyone know of a way to limit broadcast of VLAN SSIDs on the Access Points that are connected to the managed switches?
Thank you,
Neil
Hey Neil
I have not used v3 of the controller so excuse if this is not the same as v4 - had a look at the emulator for OC200
However i believe you can go to the AP specifically and choose to enable / disable the broadcast of specific SSIDS on that AP. That might be an option for you?
