Business Community > All Threads > TL-R605 trunking
< All Threads

TL-R605 trunking

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-R605 trunking

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R605 trunking
TL-R605 trunking
2020-12-29 04:34:28
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.0.0 Build 20200930 Rel.36519

I'm in the middle of migrating to the TL-R605 from an edge router. I'm unable to properly configure the LAN port to utilize 802.1q trunking. I have a cisco 3560 setup for trunking to the LAN port on the TL-R605. I have 3 interfaces configured under Wired Networks > LAN in Omada 4.2.4. Only the default interface I can't delete works. How to I setup tagging on the LAN interface to get this to work? I do not think I can configure trunking with the cisco switch using Omada 4.2.4.

  0      
 
  0      
 
#1
Options
1 Reply
Re:TL-R605 trunking
2021-01-04 09:57:40

Dear @Tyrant1919,

 

How to I setup tagging on the LAN interface to get this to work? I do not think I can configure trunking with the cisco switch using Omada 4.2.4.

 

After you configure Interface for the specific LAN port under Wired Networks > LAN in Omada V4.x, the corresponding LAN port of the TL-R605 will be trunk. For the Cisco switch, it cannot be managed by the Omada Controller, you may configure turnk with its own management tool.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1737

Replies: 1

Related Articles
TL-R605 IPv6
1692 3
TL-R605 Performance
7771 1
Deploying the TL-R605...
975 0
TL-R605 WAN Setup
2507 0
Differences between TL-R605 and ER605
15094 2
DHCP Relay on TL-R605
7752 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.