Policy Routing gets simply ignored OMADA SDN with TL-R605
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Two wan ports:
Policy: Select all internal networks -> Select ip_any ->disable "use other wan port if this is down"-> WAN2
wan 2 is connected to a switch and the only other item in the switch is the uplink router
unplugging the router now makes the traffic still go over WAN1.
Expected behaviour since "use other wan port" was disabled: Clients have no internet anymore
Any solutions?
(ofcourse i don't take away the router usually but whenever things get busy the tp link router starts to do load balancing rather than following his rules)
@Fae Hello Fae, thank you for all your efforts and your activity here.
As requested here the topology:
And here are the configs:
@Martin_Theobald I guess, you may need to check the port status of SG2008P. Red ports should be tagged, and if green ports are used to connect terminals, should be untagged.
