EAP225 V3 - Rename OR BusyBox Guide
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP225 V3 - Rename OR BusyBox Guide
Hi All,
Is it possible to rename the EAP225 v3 System Name when the AP is in Stand-Alone Mode (Not Using an Omada Controller). Typically it is designated as EAP225-xx-xx with the "xx-xx" being the MAC Address of the WAP.
If I SSH into the unit I see that it is running a version of BusyBox. Is this at all useful for configuring the AP? and is there some kind of Command Reference or Guide for this BusyBox environment. Perhaps the ability to dump the configuration out to a text file or text format a.k.a you could run the "show configuration" command and get back the running configuration.
Thank you.
1 Accepted Solution
Re:EAP225 V3 - Rename OR BusyBox Guide-Solution
>> Omada EAP Firmware Trial Available Here <<
*Try filtering posts on each forum by Label of [Early Access]*
Re:EAP225 V3 - Rename OR BusyBox Guide-Solution
>> Omada EAP Firmware Trial Available Here <<
*Try filtering posts on each forum by Label of [Early Access]*
