Welcome @groovines,

Are you running the Omada SW?  Or do you have an OC-200?

As Fae said, you'll need to use the new/current version of the Omada/SDN software to be compatible with the updated EAP225-OD drivers.

-Jonathan

@Fae thanks!  I'll try updating server software tonight . the only fear is that if something goeas wrong  my indoor EAP255 that is currently working just fine will croak and leave me w/o any wifi . afrer all its' 2020 so what elese can possibly happen:-)

@JSchnee21 

Hi Johnantan, thanks for response,. I'm just running web based server . My AP's are plugged to some Netware POE's 

i'm going to run the server software update tonigth 

Hi @groovines,

Sounds good.  A new version of Omada is out both for standalone SW and OC-200.  But be advised, it's not a seemless upgrade from Omada to the new SDN.  You'll need to reconfigure your setup under the new SDN software.

-Jonathan

@JSchnee21 

thanks so much Jonathan, I have not done the upgrade yet . Most of Florida Keys lost internet yesterday . 

regarding reconfiguration; Do you know if there are any specific instructions or videos available that i could read/watch before i mess something up 

really appreciate your help 

@groovines 

i upgraded the controller to 4.2.4  and both outdoor AP's are working now. however indoor 225 says it's incompatible with the server. i did check the compatibility list and it should be fine . any ideas? 

also i end up with two unsecured wifi networks . (2.4 and 5) wod do i hide them ? 

@groovines 

never mind ! my fdirst firmware upgrade on 225 indoor did not take and this caused both issues. All is good now. THank you guys for help Very very much