TPLink Jetstream T2600G-52TS VLAN Problem
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
So we have a TPLink-Jetstream 48Port Managed Switch and we setup VLAN20, VLAN30, VLAN40, VLAN50, VLAN60 for example in VLAN20 we setup the members 1/0/2 - 1/0/48 Untagged and 1/0/1 Untagged then saved then go to "Port Config" 1/0/2 PVID = 20 "Ingress Checking = Enabled", "Acceptable Frame Types = Admin All".
My VLAN1 is in default option with 1/0/1-1/0/48 Untagged Ports.
VLAN20 Network Address = 10.10.20.0/24
So from a PC I added a static IP addr, 10.10.20.5 and Gateway as 10.10.20.1
By the way, my TPLink Switch Port 1/0/1 is connected to an Unifi EdgeSwitch L3SW were my SVI(Switch Virtual Interface) configured.
I'm confused to about the VLAN tag and untagged. So if I want a port to only use VLAN 20 then I would setup that port tagged? and If 1 Port uses 2-3VLANs should I set it to Untagged Port?
