This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Tl-R600VPN V4.0 - Please help on WAN and NAT Speed.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
If anyone could help me on this I would really appreciate it.
My configuation is as follows:
WAN 1. VDSL 70 Mbps Down 10 Up (Tested direct to computer)
WAN 2. LTE 90 Mbps Down 40 Up (Tested direct to computer)
On the LAN, when running any multi thread speed test,
I get Down a burst at 120-130 Mbps and then it settles at arount 102-103 Mbps
I get on the Upload side 48-50 Mbps consistent,
Now my question is the following why can't I get around 70 + 90 = 160 Mbps Down. I do get around 50 up ( 40 + 10).
I read in the specs of the V4 that the NAT throughput is 680 Mbps.
Is this overstated? is the NAT limited to around 100 Mbps which would explain why I can not get 160?
Thank you for your help.
Geoffroy
https://www.tp-link.com/en/business-networking/vpn-router/tl-r600vpn/#specifications
| PERFORMANCE | |
|---|---|
| Concurrent Session | 20000 |
| NAT Throughput | 680Mbps |
| IPsec VPN Throughput (3DES) | 13Mbps |
The NAT throughput should not limit your speed. But I think it's hard to require the full speed of both WAN. The traffic will go to two WAN randomly. You can try to set up bandwidth in WAN settings according to your actual bandwidth(70M and 90M). Then enable loadbalance and enable bandwidth based balance routing on ports. Cannot make sure if it can help, just for a try.
