Link Backup Issue In TP Link R480T + Load Balancer

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Link Backup Issue In TP Link R480T + Load Balancer

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

madleme

2020-03-25 11:47:49 - last edited 2021-04-19 11:24:42

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-03-25

Link Backup Issue In TP Link R480T + Load Balancer

2020-03-25 11:47:49 - last edited 2021-04-19 11:24:42

Model: TL-R480T+

Hardware Version: V9

Firmware Version: 9.0.2 Build 20180926 Rel.34538

Hi everyone!

Could someone help me?

I followed the manual of TP Link R480T+ to setup an failover for WANs as image bellow shows. It works fine literally when WAN1 fails the WAN2 assumes. However when WAN1 comes up the WAN2 continues working. I didnt not found nothing on manual or forum about this.

- WAN1 is better, fibrechannel, 50Mb full

- WAN2 is precarious, wireless, 6Mb download - 3Mb upload

- Online Detction setting is: Manual, Ping 8.8.8.8, DNS Lookup 8.8.4.4