EAP-225 Outdoor keeps disconnecting
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
I am extending my WiFi outdoors on my hobby farm, and I am having a problem with my EAP-225 outdoor. It keeps disconnecting from the network, the light starts slowly flashing green, and I am not sure I understand why. I have a Synology rt2600ac as my primary router, with mesh throughout the rest of the indoors. I wanted to be able to get to my barn with outdoor connectivity. I have the EAP225-outdoor wired to the OC200 (I want remote access to check on things while I'm traveling). Right now the connection is TPLINK unmanaged switch--> 100-foot cat 6--> EAP injector--> 25 foot cat 6-->Waterproof coupler-->6 foot outdoor cat7-->EAP225 outdoor. I am not sure if i am missing a setting in either my Synology router or in the configuration of the EAP225-Outdoor. I have set a static IP and also tried dynamic and seem to disconnect every hour or so. Looking in the controller log it seems like it goes back to the fall back IP address for some reason and then disconnects. I do not see any conflicting IP addresses on my network. I don't know if I should be looking for a setting or maybe I am doing the static IP address wrong, or if I have hardware failing somewhere. I have had this set up for a couple of weeks, and it worked well at first but now it seems to be disconnecting.
From the log-
93-DA) connected to LAN 2020-01-15 10:42:59
93-DA) disconnected from LAN 2020-01-15 10:32:44
From the EAP225-Outdoor (Up for about 10 minutes)
LAN-
Rx Packets:
290
Rx Bytes:
67.97 K
Rx Drop Packets:
1
Rx Errors:
0 Bytes
Tx Packets:
183
Tx Bytes:
28.14 K
Tx Drop Packets:
0
Tx Errors:
0 Bytes
Radio-
Mode:
802.11b/g/n mixed
Channel Width:
20/40MHz
Channel:
11 / 2462MHz
Tx Power:
23
Rx Packets:
2930
Rx Bytes:
806.18 K
Rx Drop Packets:
0
Rx Errors:
0 Bytes
Tx Packets:
2374
Tx Bytes:
525.51 K
Tx Drop Packets:
0
Tx Errors:
1 Bytes
