Sier wrote

Hello , good afternnon guys

 

So to the point,  i want to share internet to another building ( around 300mts. ) using 2 TP-Link TL-WA7510N and seting up the second TP-LInk to distribute Wi-fi to inside the second building.

I did some internal testing and managed to setup one equipment to Acess Point , connected Lan into my network and the POE inside the WA7510 .

In the second equipment i used  client mode and connected this one to the acess Point .

I can see the wireless connection on my phone , i can connect and have internet , tho the problem lies in the range . If i move my phone 10 meters away ( maybe less ) from the client i get 0 Wi-fi signal , if i go closer to the client i get full wi-fi signal .

Im having a hard time beliving the equipment has such low range to distribute wi-fi.

Note : This was internal testing inside of a building on the same floor . Both equipaments are at around 10 meters of range of each other .

 

Any tips on what could possible be wrong that is causing the wi-fi signal in the client so weak?

 

Dear Sier,

Thanks for the kind feedback.

For the wireless coverage problem, the TL-WA7510N has a radiation angel which is Horizontal: 60° and Vertical: 14° , please check if your wirelss device is in the radiation angle.

What's more, if you want to share wirelee connection, the topology AP))))Client----indoor AP is more suggested.

Thanks.

Hello , tks for your reply .

Is there any way to boost the client wi-fi signal to spread inside the floor?

Because the client is gonna be instaled close to a window and its pointing towards the client on the other building but its not pointing towards the devices that will connect to the client via wi-fi , its actually in the oposite direction .

What can i get or do to amplify the client wi-fi signal so that in the floor where the client is instaled i have relative good wi-fi coverage?

Any tips would be glady apreciated.

Thanks for the explanation , i finaly understood  what u mean and why i was failing .

Using the omnidirectional indoor wi-fi do i need to change the configuration of the entire setup?

Using your image as suport for the descrition and trying to explain my hopefully last doubt

AP -> Client -> Should the omnidirectional wi-fi also be client and connect to the AP? Or since we have another equipment added to the network do we need to change the entire  setup?

Whats the best in terms of configuration for this setup in the image u provided ?

Again very thanks for your support .

Hi Sier

I am also using 2 TP-Link TL-WA7510N to share internet for my friend and I who live opposite each other. When the company Xpress Networks installed it for us, they gave us a extra antenna also, because i had the same problem as you when we first started using the TP-Link from another company. Maybe try getting another antenna or try putting it on wireless internet mode. If you are still having trouble check https://xpressnetworks.co.za. They were really helpful to me.

Hello guys , Again thanks for the help R1D2 , im not gonna change anything on the previous setup that u sugested, im gonna order the TL-WA901ND and im gonna install it in the center of the area where i want to have Wi-fi distributed and test it .