vpn multisite or multicliente withe route between us
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Dear, I had 3 devices one er6120 and two r600 vpn.
My question is, how can I do for there is communications beetwen the sites bellow.
I know how to do with pfsense, but with tp-link solution I dont know yet.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
If you mean that you need three sites to communicate with each other, you can set up two entries of LAN to LAN VPN on each router, then each router will establish VPN tunnel with other two routers.
- Copy Link
- Report Inappropriate Content
Welliton wrote
Dear, I had 3 devices one er6120 and two r600 vpn.
My question is, how can I do for there is communications beetwen the sites bellow.
I know how to do with pfsense, but with tp-link solution I dont know yet.
Hi Welliton:
Is this the IP address of WAN?
If this is the IP address of LAN, As Anderso said, You can configure VPN.
But if this si the IP address of WAN, You can not connect them.
Old ER6120 support routing mode, But R600VPN do not support.
- Copy Link
- Report Inappropriate Content
Andone wrote
If you mean that you need three sites to communicate with each other, you can set up two entries of LAN to LAN VPN on each router, then each router will establish VPN tunnel with other two routers.
If all of your routers WAN IPs are public, then configuring IPSec tunnels are the most common way. There is no VPN Hub feature, so configure it each-to-each.
- Copy Link
- Report Inappropriate Content
Its the local ip, but each router there is a wan with.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1193
Replies: 6
Voters 0
No one has voted for it yet.