EAP controller software Initializing error / Error:port 29810 is already in use
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP controller software Initializing error / Error:port 29810 is already in use
Model : EAP225(US)
Hardware Version : 2.1
Firmware Version :
ISP :
I want to use the controller software but I got this error:
Any ideas on how to connect using other port ? or fixing that error
Thank you
Hardware Version : 2.1
Firmware Version :
ISP :
I want to use the controller software but I got this error:
Any ideas on how to connect using other port ? or fixing that error
Thank you
Re:EAP controller software Initializing error / Error:port 29810 is already in use
The error message is very obvious now: Port 29810 is already in use.
Port 29810 (UDP) is the eap discovery port which is used for discovering Omada Controller.
Please check if which program occupies this port and try to end it by running the following commands:
Command to kill the program which occupies a specific port:
1. netstat -ano | findstr [port]
2. tasklist | findstr [PID]
3. taskkill /f /t /im [program_name]
Port 29810 (UDP) is the eap discovery port which is used for discovering Omada Controller.
Please check if which program occupies this port and try to end it by running the following commands:
Command to kill the program which occupies a specific port:
1. netstat -ano | findstr [port]
2. tasklist | findstr [PID]
3. taskkill /f /t /im [program_name]
File:
