EAP225 batch adopt

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP225 batch adopt

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP225 batch adopt
EAP225 batch adopt
2017-07-23 04:06:22
Model :

Hardware Version :

Firmware Version :

ISP :

I'm a beginner at Access points and bought a couple of access points for my home but cannot get the EAP225 to batch adopt. It says batch adopt will take a few minutes and to click refresh to see the status. I've waited several hours but nothing happens. Any help would be appreciated.
  0      
  0      
#1
Options
2 Reply
Re:EAP225 batch adopt
2017-08-03 15:06:05
I think you might have typed wrong username/password of EAP225, thus they will not be able to be adopted by EAP controller, and nothing will happen as you see.
So please double check the username/password of your EAP225, if you don't know what it's, you can do a hardware reset and then it will be admin/admin by default.
Hope this helps you.
  0  
  0  
#2
Options
Re:EAP225 batch adopt
2018-12-24 08:00:31 - last edited 2018-12-24 08:19:50

hello guys, i set the access point, first time connecting, after update firmware don't connecting.

i have error but i put right username and password

 

 

failed sent adopt 

 

This operation will take a few minutes, please refresh to view the adopt result.
Notice: The device which was managed by others will not be adopted.

  0  
  0  
#3
Options