EAP 225, No SSID after adoption
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP 225, No SSID after adoption
Model :
Hardware Version :
Firmware Version :
ISP :
I have two EAP 225 APs. When I adopt them into the controller software the controller shows "provisioning" and does not connect. When I then login to the web interface of the APs, they are without an SSID. The previous default SSID or any new one that I set using the web interface on the AP, is removed and the SSID is blank. What to do? So far I cannot use the Controller.
Dwight
Hardware Version :
Firmware Version :
ISP :
I have two EAP 225 APs. When I adopt them into the controller software the controller shows "provisioning" and does not connect. When I then login to the web interface of the APs, they are without an SSID. The previous default SSID or any new one that I set using the web interface on the AP, is removed and the SSID is blank. What to do? So far I cannot use the Controller.
Dwight
