The PoE Passthrough option does not appear in tplink cpe 220 v2.0
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hardware Version : V2.0
Firmware Version : pharos-up-ver2-0-0-P2[20161117-rel38185].bin
ISP :
I have received some CPE220 V2.0, and I noticed that the "PoE Passthrough" option does not appear in the "MANAGEMENT" menu. I request information on this subject. Thank you
@Boris01 hi im get problem with my cpe 220.cant ping and access the web management,i also try reset by press reset button on the device but still doesn't work.i try at several time to reset it,but still same.can't access dan ping management ip.please answer it see my attach below
note : i was change the cable and make sure the cable works,
indicator power and lan0 on,indicator LAN connection on laptop on
InaAddict wrote
A device with IP 192.168.0.10 (either your local PC or a remote router set as the default gateway) tells you that it can't resolve the IP 192.168.0.254.
This means you either have a routing problem in your network or the CPE actually has another IP. I recommend to load factory defaults on the CPE by pressing the RESET button for 7-10 seconds. Then check IP settings of your PC and try again.
BTW: you're replying to a three year old thread. It's better to create a new thread for any issues unrelated to the original question if you expect an answer to your question.