I meant "nothing happes", i.e. when I clicked on 'Apply' there was no feedback at all and the change wasn't saved. If I went to another screen after changing the IP for example and then returned the IP hadn't been changed..


It would seem that it was just a one-off situation, I turned the switch off and then on again and now it works as it should. When I click on 'Apply' I get a yellow response line saying that my change has worked.

Now I can play and see if it does what I need! :-)

I can log in to the web configuration GUI without any problems but I can't actually change anything. When I click on the 'apply' or 'save' buttons nothing happens at all.

I also like you




I also like you

Hello,

i have the same problem of you. It's impossible to write the config with the last firmware ( 1.0.2 Build 20160526 Rel.34615)

I hope this problem will have a solution promptly. if not, I will send the material to amazon for default.
I use as browser google chrome ( 60.0.3112.113 (64 bits) ) in OSX (10.12.6 ).

Cedric

I think that you also have to click on the sixth option, Save Config, in the list to the left, after you have done all of your Apply clicks.



System
[*]Switching
[*]Monitoring
[*]VLAN
[*]QoS
[*]Save Config

[*]



Logout