2 x CPE210 (ap mode + client) & EAP110-Outdoor Vlan
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
2 x CPE210 (ap mode + client) & EAP110-Outdoor Vlan
Model :
Hardware Version :
Firmware Version :
ISP :
Hi All,
I have some troubels/questions about vlan passtrough on CPE210.
My setup:
CPE210 (ap mode) is connected to vlan switch
Eap110-outdoor has 2 ssid's with different vlan's, the lan port of the EAP110 is connected to the CPE210 (client)
On my network there are several EAP's each with 2 vlan's (private & hotspot netw).
The EAP's on my network are doing fine, so the vlan's are working private goes to router, hotspot goes to (external captive portal).
Problem:
When a device connects to ssid for hotspot, he isn't in the correct vlan (doesn't receive ip from correct range & isn't getting captive portal).
How can I make sure the CPE210's are passing trough the vlan tag?
Already thanks for your reply.
E-raser
Hardware Version :
Firmware Version :
ISP :
Hi All,
I have some troubels/questions about vlan passtrough on CPE210.
My setup:
CPE210 (ap mode) is connected to vlan switch
Eap110-outdoor has 2 ssid's with different vlan's, the lan port of the EAP110 is connected to the CPE210 (client)
On my network there are several EAP's each with 2 vlan's (private & hotspot netw).
The EAP's on my network are doing fine, so the vlan's are working private goes to router, hotspot goes to (external captive portal).
Problem:
When a device connects to ssid for hotspot, he isn't in the correct vlan (doesn't receive ip from correct range & isn't getting captive portal).
How can I make sure the CPE210's are passing trough the vlan tag?
Already thanks for your reply.
E-raser
