TP Link Load Balancer TL-R480T+ Failover to Load Balance/combining two different WAN
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP Link Load Balancer TL-R480T+ Failover to Load Balance/combining two different WAN
Model :
Hardware Version :
Firmware Version :
ISP :
Hi all,
I have a TP Link Load Balancer TL-R480T+ configured as failover. Now, I want to reconfigure the settings to load balance again. I tried several steps taken from some research but still I cant combine 2 different WANS. I also put the status on link backup as INACTIVE. But when I checked the internet speed, it is still the same ( by the way my WAN1 is bayantel with 10mbps and WAN2 is globe with 20 mbps.) I still get the speed of bayantel wich is 10mbps. My question now is how do I reconfigure my loadbalancer back to load balance and combine the two different WAN.
I hope someone with greater knowledge can help me.
Thank you.
Hardware Version :
Firmware Version :
ISP :
Hi all,
I have a TP Link Load Balancer TL-R480T+ configured as failover. Now, I want to reconfigure the settings to load balance again. I tried several steps taken from some research but still I cant combine 2 different WANS. I also put the status on link backup as INACTIVE. But when I checked the internet speed, it is still the same ( by the way my WAN1 is bayantel with 10mbps and WAN2 is globe with 20 mbps.) I still get the speed of bayantel wich is 10mbps. My question now is how do I reconfigure my loadbalancer back to load balance and combine the two different WAN.
I hope someone with greater knowledge can help me.
Thank you.
