EAP Controller LED Settings

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP Controller LED Settings

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

binary

2017-02-27 17:45:44

Posts: 6

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2017-02-11

EAP Controller LED Settings

2017-02-27 17:45:44

Model :

Hardware Version :

Firmware Version :

ISP :

Hi there,

i just have a "nice to have" Wish. Can you please add a LED Setting feature in the EAP Controller software , so i can switch the LED to on or off for specific APs?
We have some AP locations where the LED light is a little bit too bright. So we want to switch it off. On other APs in the same Site it should be on.

Is this possible?

thank you
Best
Ronald

2 Reply

DocJones

LV2

2017-03-20 19:15:14

Posts: 38

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2017-03-19

Re:EAP Controller LED Settings

2017-03-20 19:15:14

I do think it would be good to configure this on a per-AP basis, but in the meantime are you aware of the system-wide LED setting? If you go Settings > System > LED you can turn off the LEDs for all APs.

binary

LV1

2017-04-02 15:35:25

Posts: 6

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2017-02-11

Re:EAP Controller LED Settings

2017-04-02 15:35:25

Hello DocJones,

thanks for the reply. I know the LED Setting in the EAP Controller. If i connect APs to the EAP Controller, each AP takes the LED Settings from EAP Controller no matter i configured before on the AP himself. I want to seperate the LED Settings for each AP or at least for a group. This would be very nice. As sayd before, this is just a nice to have feature or a cosmetic thing, but for me this would be a feature for a holistic business solution!

EAP Controller LED Settings

EAP Controller LED Settings

Information

Voters 0

Tags