Business Community > Pharos Wireless Bridges > Network Addresses
< Pharos Wireless Bridges

Network Addresses

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Network Addresses

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Network Addresses
Network Addresses
2017-01-06 18:12:31
Model : CPE210

Hardware Version :

Firmware Version :

ISP : Plusnet

Hi, I want to connect two CPE210 in Point to Multipoint mode. How do I address a device such as network printer connected to an AP Client Router from the gateway
netework? Thanks
  0      
 
  0      
 
#1
Options
5 Reply
Re:Network Addresses
2017-01-10 07:05:27
Access the network printer from where? AP Client Router mode isolates the local network, which is connected wirelessly to the WISP provider. The CPE210's WiFi is part of the WAN network, your devices connected by wire to the CPE share an isolated, separate network being routed. Usually the devices of this network are not accessible from the outside. See picture below, note the IP addresses/subnets.



༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Remote Connections
2017-01-10 16:37:21
Many thanks for your comments. I have a siutation where devices are connected to the gateway router as well as the AP 210. I was hoping I could set up a remote network using a second 210 my problem is distance, the second network is beyond the 300ft of a standard wired network. Regards Dave
  0  
  0  
#3
Options
Pharos Maxtream
2017-01-10 16:50:58
Hi R1D2, would it be possible to use MAXtream to extablish a point to point connection? Kind regards Dave
  0  
  0  
#4
Options
Re:Network Addresses
2017-01-10 17:37:24

GreenwichYC wrote

Hi R1D2, would it be possible to use MAXtream to extablish a point to point connection? Kind regards Dave


Yes, but it would be of no much use if you have only a true PtP setup with two CPEs. If you connect more than one CPE client to your AP, it can help to equally distribute air-time to the clients.See http://www.tp-link.com/lk/faq-694.html for an introduction into MAXtream technology.
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#5
Options
Re:Network Addresses
2017-01-11 01:49:28
Maybe you could put the CPE in BRIDGE, not in a router. By placing them in this mode, the devices (AP and Client or clients) will be totally transparent to the network, and the wireless connection will be made as if it had placed a cable between them ...

And any device can reach anyone who is connected to the network ..., And the only device that will assign the IP addresses, will be the main router through its own DHCP

Regards...
  0  
  0  
#6
Options

Information

Helpful: 0

Views: 867

Replies: 5

Related Articles
 Can't ping static ip addresses on my network
777 0
Fixed IP Addresses not Being Assigned
431 0
 Unable to have guest network issue it's own ip addresses
614 0
how to assign addresses to omada managed devices
1754 0
S2S VPN, only DHCP addresses seen
547 0
Omada constantly assigning IP addresses
349 1
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.