TL-POE10R NOT COMPLIANT IEEE802.3af
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-POE10R NOT COMPLIANT IEEE802.3af
Model :
Hardware Version :
Firmware Version :
ISP :
I have a PSE (Switch POE) that supports IEEE802.3af mode A only, but if I use it with TL-POE10R I cannot power on my POE devices. It appears that TL-POE10R supports just the IEEE802.3af mode B. And it IS NOT STANDARD compliant. Infact the mode (A or B) is decided by the PSE and not by the device, so as stated by the standard definitions:
"The PSE (power sourcing equipment), not the PD (powered device), decides whether power mode A or B shall be used. PDs that implement only Mode A or Mode B are disallowed by the standard."
Then the TL-POE10R is definitively NOT IEEE802.3af standard.
Hardware Version :
Firmware Version :
ISP :
I have a PSE (Switch POE) that supports IEEE802.3af mode A only, but if I use it with TL-POE10R I cannot power on my POE devices. It appears that TL-POE10R supports just the IEEE802.3af mode B. And it IS NOT STANDARD compliant. Infact the mode (A or B) is decided by the PSE and not by the device, so as stated by the standard definitions:
"The PSE (power sourcing equipment), not the PD (powered device), decides whether power mode A or B shall be used. PDs that implement only Mode A or Mode B are disallowed by the standard."
Then the TL-POE10R is definitively NOT IEEE802.3af standard.