R600VPN and PPTP
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
R600VPN and PPTP
Model :
Hardware Version :
Firmware Version :
ISP :
So I am able to connect to the R600VPN from my PC and phone just fine when I am on the road over PPTP. The problem is I cannot see my internal network.
I setup my VPN network to assign 192.168.0.60 -> 69 to the PPTP clients. That all seems to work just fine. I can access the router's configuration page when logged into the VPN.
However, when I connect-- the router creates a route from the VPN client to the WAN with a 255.255.255.255 subnet mask. Nothing goes internal. Sort of defeats the purpose.
I am trying to connect with a Mac or OSx device.
I can't be the only one with this issue. I tried updating the firmware and statically assigning a route but I have not had any luck.
Hardware Version :
Firmware Version :
ISP :
So I am able to connect to the R600VPN from my PC and phone just fine when I am on the road over PPTP. The problem is I cannot see my internal network.
I setup my VPN network to assign 192.168.0.60 -> 69 to the PPTP clients. That all seems to work just fine. I can access the router's configuration page when logged into the VPN.
However, when I connect-- the router creates a route from the VPN client to the WAN with a 255.255.255.255 subnet mask. Nothing goes internal. Sort of defeats the purpose.
I am trying to connect with a Mac or OSx device.
I can't be the only one with this issue. I tried updating the firmware and statically assigning a route but I have not had any luck.
File:
Screen Shot 2016-09-05 at 9.32.54 PM.pngDownload