Configuration Issue after changing default IP
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Configuration Issue after changing default IP
Model : TL-SG2424
Hardware Version : V1
Firmware Version : 1.0.7 TL-SG2424_V1_150713
ISP :
Hi All,
i upgraded my SG2424 to the latest Firmware.
Then i changed the Default IP-Address to 192.168.100.4/24 and the Managemet VLAN to 100.
My Client is in VLAN100 and in the Subnet-Range.
After Login to the Switch with new IP-Address i cannot configure any things. After clicking some Subsites (e. g. System IP), the Startscreen will appear.
So my only way is to pull the Power and Reboot the Switch. Of course, the Switch is now reachable by the defaul IP (192.168.0.1), i could not save the config.
On older Firmware i could Change the Default-IP without Problems.
Could you please help me?
Thanks and regards,
Bernhard
Hardware Version : V1
Firmware Version : 1.0.7 TL-SG2424_V1_150713
ISP :
Hi All,
i upgraded my SG2424 to the latest Firmware.
Then i changed the Default IP-Address to 192.168.100.4/24 and the Managemet VLAN to 100.
My Client is in VLAN100 and in the Subnet-Range.
After Login to the Switch with new IP-Address i cannot configure any things. After clicking some Subsites (e. g. System IP), the Startscreen will appear.
So my only way is to pull the Power and Reboot the Switch. Of course, the Switch is now reachable by the defaul IP (192.168.0.1), i could not save the config.
On older Firmware i could Change the Default-IP without Problems.
Could you please help me?
Thanks and regards,
Bernhard