TL-ER604W Not getting full ISP bandwidth

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-ER604W Not getting full ISP bandwidth

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-ER604W Not getting full ISP bandwidth
TL-ER604W Not getting full ISP bandwidth
2016-05-15 22:10:53 - last edited 2021-08-21 06:35:49
Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

Region : United StatesModel : TL-ER604WHardware Version : V1Firmware Version : 1.1.0 Build 20141031 Rel.32628sISP : Bright HouseFirmware Version: 1.1.0 Build 20141031 Rel.32628s Hardware Version: TL-ER604W v1.0Not sure if it's always been like this but our ISP just upgraded our internet quite drastically and I figured I'd try a speed test. Only got between 120 and 140Mbps down every test. ISP said it should be 300. I was about to call them but figured I'd try going directly to modem. Did that and was pulling between 350 and 400Mbps. Tried removing every other device from router to see if that was an issue but still had the same results. Made sure to test with all of the same cables and just bypass the router with no luck.Thanks for any help in advance.
  0      
  0      
#1
Options
2 Reply
TL-ER604W Not getting full ISP bandwidth
2016-05-16 05:25:32 - last edited 2021-08-21 06:35:49
Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

Region : United States
Model : TL-ER604W
Firmware Version: 1.1.0 Build 20141031 Rel.32628s
Hardware Version: TL-ER604W v1.0
ISP : Bright House


Our ISP recently upped our bandwidth to 300/30Mbps and I figured I'd test it and noticed I was getting tops 120-140Mbps down, but getting the full up speed of 30Mbps. Tried swapping out cables, rebooting router, removing all other devices, etc with no luck still getting the same results. So I went directly to the modem and immediately got between 350-400Mbps every test. Looking for any suggestions.

Thanks for your help in advance.
  0  
  0  
#2
Options
Re:TL-ER604W Not getting full ISP bandwidth
2016-06-02 09:07:51 - last edited 2021-08-21 06:35:49
Hi dstnzrkl, the NAT throughput of the TL-ER604w is 160Mbps as you can see in their official website. No wonder you get a test result as 120-140Mbps. I am afraid if you want to make full use of the bandwidth, you need to change the router to a better one, like TL-ER6120, it has 350Mbps NAT throughput.
  0  
  0  
#3
Options