TL-WA7210N bridge mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-WA7210N bridge mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-WA7210N bridge mode
TL-WA7210N bridge mode
2016-01-30 23:28:37
Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

I need to connect my home and office network, but I can't connect primary TL-wa7210n device with cable. is there option to create bridge over wifi? I mean can I connect AP1 to my local router over wifi? (see http://www.tp-link.com/en/faq-719.html )
  0      
  0      
#1
Options
2 Reply
Re:TL-WA7210N bridge mode
2016-02-01 01:01:14

Piter wrote

need to connect my home and office network, but I can't connect primary TL-wa7210n device with cable. is there option to create bridge over wifi?

I don't like bridge mode I prefer AP-Client
AP-http://www.tp-link.com/en/faq-716.html
Client http://www.tp-link.com/en/faq-318.html
If you prefer Bridge here
How to configure the bridge with AP mode on the TL-WA7210N?
http://www.tp-link.com/en/faq-717.html
  0  
  0  
#2
Options
Re:TL-WA7210N bridge mode
2016-02-02 05:18:36
Hello,I have a setup with 2x wa7210n over 1.2km.Unit 1 set as AP, wired to a router that connects to Internet.Unit 2 set as Bridge with AP and has a wired connection to a switch with 3 IP cameras wired to the switch.Everything works ok, but my question is should I be using bridge with AP or should I just use client mode?It is handy having the Wifi AP at the unit 2 end but not essential. I could just run a simple wifi AP from the switch if needed.Thanks
  0  
  0  
#3
Options