Region : Germany

Model : TL-SG2424

Hardware Version : Not Clear

Firmware Version :

ISP :

Hello,


I've a question concerning Link Aggregation. I want to use my Synology NAS and my MacPro with Link Aggregation on the Switch.


I can only manage to get one working at the time!?


I go to: Switching/LAG/LACP Config and select Port 23 and 24 (for my MacPro) and set them to active and enabled. My MacPro is then successfully connected to the switch and the Link Aggregation is working.


The same is working when I select Port 21 and 22 (for my Synology NAS) it also shows a 2000 MBit connection.


But how do I enable this for both devices? Whenever I enable Port 21, 21, 23 and 24 together only one of the devices can connect to the switch.


I thought it would be possible to have Port 21 and 22 in a group f.e. LAG1 and Port 23 and 24 in LAG2. This is just possible when I activate the static LAG but with this activated none of my devices can connect to the switch.


Any help is much appreciated!


Best regards,


David