CPE210 as Routing Client, no NAT, no Bridge

CPE210 as Routing Client, no NAT, no Bridge

CPE210 as Routing Client, no NAT, no Bridge
CPE210 as Routing Client, no NAT, no Bridge
Monday - last edited Yesterday
Model: CPE210  
Hardware Version: V2
Firmware Version: 2.2.1

Newbie question, apologies in advance :^/

 

I have a CPE210 as a central access point on a backbone.  It connects with several remote locations.

Each remote location is another CPE210 that fronts an independent subnet.  I want to have routing

between each remote subnet and the backbone subnet, not bridging. 

 

How can I configure the remote CPE's to perform routing, without NAT?

 

 

AP Client Router mode seems appropriate; it's got "router" in the name :^) but that's not working.

I found the "DMZ" option but that gets me to only one host in each subnet.

There's also port forwarding but that's cumbersome and a pain to setup for each app that I use and every new host added blah blah...

 

My crude drawing:

 

Thanx!

-- Steve

  0      
  0      
#1
Options
1 Accepted Solution
Re:CPE210 as Routing Client, no NAT, no Bridge-Solution
Yesterday - last edited Yesterday

Hi  @Fall-Mountain 

 

You can do this with CPE210 since it doens't support to deliver packets in different subnets.

Recommended Solution
  0  
  0  
#3
Options
1 Reply
Re:CPE210 as Routing Client, no NAT, no Bridge-Solution
Yesterday - last edited Yesterday

Hi  @Fall-Mountain 

 

You can do this with CPE210 since it doens't support to deliver packets in different subnets.

Recommended Solution
  0  
  0  
#3
Options