Hello all,

Let me say thanks in advance for any help offered. I am very new to wireless bridges, so please bare with me if i dont give enough info in this initial post.

I am trying to set up a PtP bridge between my house and my pole building, about 300 feet away from each other, with two cpe210's. I have my home router wired to one cpe210 that is in AP mode and the second cpe210 is in client mode and is feeding a wireless router. I am currently just bench testing this set up in my garage to get working before installing outside and I have a couple questions. 

1. How do I access the settings in pharos once I have gone through the initial set up? Every time I have wanted to change a setting I have to do the factory reset and go through the initial set up just so that my web browser will find the factory ip address of 192.168.0.254. I would think there has to be a way to get to the settings without a factory reset, right?

2. It appears I have good connection between the two radios as both have all the leds on the side lit up for signal strength, but when I plug the wireless router in on the client side, it doesn't appear in my list of available networks. However, the AP does show up as an available network. 

I have tried with max stream both enabled and disabled, the only noticeable difference seems to be that when max stream is disabled, it will allow me to connect my phone to the AP and gain internet access through that. All other settings have been left at factory default. 

If you took the time to read all this I really appreciate it. Thanks again.

Andrew