Access point EAP610: Can't access in the panel control under MESH mode.
Access point EAP610: Can't access in the panel control under MESH mode.
Hello i bought x3 of EAP610 access points.
They are working as intended ( mesh mode ), but i can't access at the menu over browser. I get this message, and i honestly can't understand why.
The firmware is already updated, plus i did the factory reset on every EAP610, before pairing the into a mesh mode.
But when i turn off the mesh mode, i can access to the panel control over browser with no problems on each one.
This happens only under mesh mode, not on standalone mode.
The problem is....i get the same message when i try to access to the MAIN AP !
Any solutions ? Thanks
