Access point EAP610: Can't access in the panel control under MESH mode.

Access point EAP610: Can't access in the panel control under MESH mode.

Access point EAP610: Can't access in the panel control under MESH mode.
Access point EAP610: Can't access in the panel control under MESH mode.
2025-01-28 15:43:41 - last edited 2025-02-06 08:49:05
Model: EAP610  
Hardware Version: V3
Firmware Version: Latest

Hello i bought  x3 of EAP610 access points.

 

They are working as intended ( mesh mode ), but i can't access at the menu over browser. I get this message, and i honestly can't understand why.

 

The firmware is already updated, plus i did the factory reset on every EAP610, before pairing the into a mesh mode.

 

But when i turn off the mesh mode, i can access to the panel control over browser with no problems on each one.

 

This happens only under mesh mode, not on standalone mode.

 

The problem is....i get the same message when i try to access to the MAIN AP !

 

Any solutions ? Thanks

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Access point EAP610: Can't access in the panel control under MESH mode.-Solution
2025-01-28 15:47:39 - last edited 2025-02-06 08:49:05

  @StIwY 

 

I don't really understand your problem :)

 

It clearly says (the message) that once the AP is configured in Mesh Mode, then it's being managed by Main AP, and you should log into that one. Not every single one ;)

 

Cheers.

Recommended Solution
  0  
  0  
#2
Options
4 Reply
Re:Access point EAP610: Can't access in the panel control under MESH mode.-Solution
2025-01-28 15:47:39 - last edited 2025-02-06 08:49:05

  @StIwY 

 

I don't really understand your problem :)

 

It clearly says (the message) that once the AP is configured in Mesh Mode, then it's being managed by Main AP, and you should log into that one. Not every single one ;)

 

Cheers.

Recommended Solution
  0  
  0  
#2
Options
Re:Access point EAP610: Can't access in the panel control under MESH mode.
2025-01-28 15:51:37
Same message appears when i also try to login to the MAIN AP.....
  0  
  0  
#3
Options
Re:Access point EAP610: Can't access in the panel control under MESH mode.
2025-01-28 16:07:36 - last edited 2025-02-06 08:49:00

  @StIwY 

 

Have you configured that Mesh using controller or Omada App [on your phone] in standalone mode?

 

If you used Omada App - have you checked there? I believe whole management is being done via app in that case:

https://www.tp-link.com/en/support/faq/3596/

 

Cheers

  0  
  0  
#4
Options
Re:Access point EAP610: Can't access in the panel control under MESH mode.
2025-01-28 17:03:09
Yes i've used Omada app, i don't have any controller
  0  
  0  
#5
Options