Hello everyone,

I have installed an EAP660-HD in a small public hall. An ER605 is also working there as a router. The two devices connect to my controller via port sharing over the Internet.

What I have now noticed, and this was also the case with another project. If you are at the limit of the WLAN signal, it sometimes takes a little longer to receive an IP, but what is much worse is that the portal is not called up. The WLAN is connected, but without an Internet connection. Only when you are much closer to the AP and dial into the WLAN again does the portal load.

I realize that if the signal quality is poor, there may not be enough data flowing. But isn't there any way to adjust the default settings? 

Best regards
Tim