Hi everyone,

 

I need some help troubleshooting a slow upload problem with my new EAP773.

 

I have a 10gbit symmetric wan, a pfsense router with 2 sfp+ and 3 2.5 rj45.

One sfp+ is connected to a xgs-pon bridge. The other to a mikrotik cs305. The rj45 port on the mikrotik is temporary connected to an old unifi us-8-60w which i’m using to power a unifi flexhd.

 

With it i can reach around 300/300 on my macbook pro m4, iphone 13 pro max and a windows pc with a wifi 6 card onboard.

 

 

 

I bought an eap 773 because i wanted to remove the unifi switch and ap, use wifi 6e and be ready for wifi 7.

 

The new ap is connected with a 10gbase-t and powered with a good quality 12v 3a adapter.

 

The problem is that the speed I can reach are around 1300/80-120).

 

 

 

Some info/stuff I tried to do:

- factory reset

- connected max 3 devices on the network

- the same port with the same adapter saturate a x550t2 on a test machine (tested iperf)

- I also tried other ports and cables with no differences

- the omada controller tells me that it correctly negotiated 10000 Mbps

- I updated the firmware to 1.0.14

- runned wlan optimization (it went from 40% to 100% as soon I shut down the old ap, but no difference with speeds)

- disabled the 6ghz network completly

- I connected it to the same port with the same cable I’m using for the flex hd (1000 negotiated, speed 1000/80)

- connected directly to a 2.5 port on the router and configured it without the controller (1300/80 again)

- all mtu's are left at default

 

- iperf3 to a remote server of my isp:

-- with -R  

-- without -R 

 

- iperff3 to lxc on a proxmox host connected to the mikrotik (same vlan, no routing trough pfsense):

-- with -R  

-- without -R  

 

- iperff3 to lxc on a proxmox host connected to the mikrotik (different vlan, routing trough pfsense):

-- with -R 

-- without -R

 

Unless I'm doing something wrong with iperf... the fact that inside my network iperf works as expected, seems to be quite significative.

 

I don't see how this could be related since I get better upload speeds with another access point, but I should mention that the wan use pppoe (single thread on freebsd).

 

Anyone has any ideas? Thank you!