EAP225_Outdoor Connected port on switch shows unknown mac ids in the client list
Hi
Current setup Out door 225 EAP and eap 265 hd plugged into SG2008P then into a ER7206. Then there is a 225 eap meshed to the out door. Mesh failover is enabled.
I keep getting this strange mac address appearing on my logs. Says connecting then disconnecting. But the port it is connecting to an already used port that has the 225 Outdoor eap connected.
I'm not sure if its the mesh network doing a check.
Would anyone know?
Thanks
Matt
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @Matt_MIKEY
If you search this MAC address from Client page, can you get any result?
Maybe it's a client connecting to the mesh EAP225.
- Copy Link
- Report Inappropriate Content
Thanks for the response.
I have checked client list, but it doesn't have an IP address and no datat sent and received. I did block the MAC address, but will try and get a screen dump and attach.
Thanks
Matt
- Copy Link
- Report Inappropriate Content
Hi Vincent
This is the results, but it doesn't get an ip address and no data is transferred.
- Copy Link
- Report Inappropriate Content
Hi @Matt_MIKEY
Thanks for that info.
We recommend submitting a support ticket via email for efficient assistance.
Please include the following information in the email:
1. this Forum ID 733170;
2. your community nickname;
3. What kind of controller are you using? cloud-based controller or hardware controller or else?
4. the firmware version of the controller;
5. the mac address of your EAPs.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 62
Replies: 4
Voters 0
No one has voted for it yet.