Hello, I am having a hard time to add the ER605 to my actual network. I am using the controller via a raspberry with 2 APs and captive portal and works properly. Once I add the ER605 to the controller, the network goes down and lost connectivity at all; once I hard reset to original config of the router, the network goes up and works properly.

This is my network configuration:

ISP    192.168.1.1/24    
LAN    192.168.0.1/27    ER605 FIRMWARE 2.2.6 (ROUTER)
CONTROLLER    192.168.0.2/27    SOFTWARE 5.14.32.3 (RBPI)

WAPs EAP610 (2 devices)

Not using VLANs, no ACL, no other advanced configuration on the network. It´s from my house the complete setup.

Eveything works properly, but I would like to add the ER605 to the Omada Controller software and when I adopt it, the network goes down and lost internal and external connectivity.

Any suggestions on how to add and to make it work all integrated? 

Thank you.