Site-to-Site VPN does not see devices on other end
Hi. Need some help here.
I have setup Automatic Site-to-Site VPN connection. Office has a FR205 unit and external site FR365.
Have opened UDP port on the modem 1164 and forward to the router. This port was documented in OpenVPN documentation.
Office has IP addresses in the 192.168.1.xx range and remote site in the 192.168.17.xx range
How can I verify that connection has been established and access devices on either site.
Thanks.
Thanks @Clive_A.
Nothing is reported. Only message shown:
I am a user of a VPN Client to server comunication. Not experienced on setting up VPN.
Should a user be setup to connect to remote site or sites should be visible when Site-to-Site is configured?
Regards.
Hi @wllmdjngh
Thanks for posting in our business forum.
wllmdjngh wrote
Thanks @Clive_A.
Nothing is reported. Only message shown:
I am a user of a VPN Client to server comunication. Not experienced on setting up VPN.
Should a user be setup to connect to remote site or sites should be visible when Site-to-Site is configured?
Regards.
If there is no tunnel displayed then the VPN is not up.
Consider the regular steps of VPN troubleshooting. It looks like they don't connect due to the IP issue. Generic IPsec Site-to-Site guide on the official website, FAQ, would be helpful in your examination.
How to set up Site-to-Site Manual IPsec VPN Tunnels on Omada Gateway via Omada Controller
How to set up site-to-site Auto IPsec VPN Tunnels on Omada Gateway in Controller Mode
You are on Site-to-Site. If possible, I recommend you draw a diagram with the IPs specified. Especially the WAN if they are actually on the public Internet.
Hi @Clive_A,
@Clive_A Still trying to setup VPN between 2 sites.
Our setup is:
Each site has dual ISP connections with modems
Only one Modem at each site is setup with DMZ zone pointing to the respective Festa router
Ping respond to both sites each with respective domain
IP range are different at each site
Created a Shared key with OpenSSL
Have no VLAN setup
Below is an image of one the router configuration. The second router is similar with the exception for the Remote Gateway and Subnets.
Advanced configuration default.
Have not been able to establish the VPN connection.
When this is accomplished, would like to be able to use hostnames instead of IP address on either side. Is this possible. Should DHCP L2 be checked for this to be enabled?
Appreciate your input.