ER605 randomly disconnects from internet
ER605 randomly disconnects from internet
My router randomly disconnects from the internet. It will work fine, then will suddenly not have internet access.
The router is physically connected to two desktop PC, a television, and a WAP. (I know this device is meant for businesses but I'm using it at home anyway.)
This problem has worsened when I started using a new WAP. It's a Netgear WAX214 (AX1800) and is connected over a LAN port using DHCP. I used to get disconnects every week or so, but now it's every 1-2 hours. Sometimes just the WAP loses internet, but most of the time it's the router.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, I've read this and few similar topics and I think this is the closest to my issue. The only difference at me is that the disconnect happens every hour after reboot, and lasts 2 to 45 seconds then WAN connection is restored automatically.
I have
ER605 v1.0
1.3.1 Build 20231207 Rel.61384
OC200 1.0
1.32.6 Build 20241101 Rel.41525
EAP245(EU) v3.0
5.0.6 Build 20220429 Rel. 44315
I.e. if the ER605 was rebooted at 6:12, the restarts happen between minutes 11-13 every hour e.g. 7:12, 8:11, 9:13 etc. WIFI still works, but the connection to WAN is down on LAN too. Sometimes I get notification in the Omada app that the OC200 is offline, but not always probably because the disconnect is often less than 10 seconds.
The log isn't much useful, all it has is:
Network Disconnection - Cloud access is disconnected due to network disconnection.
And sometimes, but not always is followed by:
Cloud Access Success - Successfully access the cloud.
The ER605 is connected to a fibre modem provided by the broadband provider. The provider investigated on their end and couldn't find any issue, and there were no recent changes to the network config either. I'm behind a provider NAT.
The issue started on 14 November and there was no change in my setup around that time.
IPv6 is not enabled, have DHCP on WAN and LAN too. No IP conflicts in log, only the disconnect/connect.
I've already rebooted everything several times both from the admin interface and by unplugging the power for 30+ minutes, all firmware are up to date, but the issue still keeps happening.
Any ideas what could cause this, and how to investigate in more details?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 182
Replies: 11
Voters 0
No one has voted for it yet.