ER605 Bandwidth control 100%cpu slow upload speed
Hi there, my setup is simple: 1 WAN + 1LAN no qos, no dpi, no app filtering. NOTHING. fully hardware offload,
just wanted to test bandwidth control (i have 1gig isp)
Set it like this, limit to 500mbps
instead of full speed i have slow upload speed. 40-50Megabits per second and 98% cpu usage
what i am doing wrong?
screen with bandwidth control ON
just uploading 1 file to FTP
screen with bandwidth control OFF
just uploading 1 file to FTP
Why just uploading single file to FTP calls 100% cpu?
@Clive_A Hi
thanks for answer.
bandwidth control ID1 is disabled, WAN2 (backup), offline.
qos, dpi, load balancing everything is disabled.
just one lan and one wan.
Today I repeat my test. and made 3 min video:
https://youtu.be/5hWNXYvGpSc
first test with disabled bandwidth control:
uploading file to ftp ~200megabits
downloading same file ~400megabits
zero cpu usage
second test with enabled bandwidth control with speeds 1000000/1000000 
:
uploading ftp ~50-70megabits
downloading same file 40-50megabits
high cpu usage
enabled
disabled bandwidth control
uploading/downloading same file to onedrive no problem. speeds are 400+ cpu usage low (no difference bandwidth control enabled or disabled)
uploading/downloading same file to fexnet no problem. speeds are 400+ cpu usage low (no difference bandwidth control enabled or disabled)
uploading/downloading same file to google drive PROBLEM. speed ~100megabits cpu usage HIGH (with bandwidth control OFF speed is 400+)
FTP File transfers are very slow.
just tested again and getting 49megabits :( on GIGABIT ROUTER
run speedtest during FTP upload shows me normal speeds. what?
Please check FTP and google drive upload on your lab/device
