5G tx-frame/rx-frame rate was displayed very high.
The wifi quality is bad again. I think I was mistaken that it was good because the client was disconnected all over while adjusting the tx value etc. I am still frustrated and want to solve this situation.
Please help me.
------------
hello. I am using it with the equipment configuration below.
ER707-M2, EAP653 3ea, PoE 5port, SG3428,
Controller ver : 5.14.26.1
One day, the wifi speed quality was not good, so I checked and found that the 5G rx/tx-frame rate was displayed very high.
I tried changing the channel, changing the channel width, and adjusting the tx power, but it didn't work.
We are a dental clinic. If we check the 5G rx/tx-frame rate at night after our work is over, it is within the normal range.
Please give me a good solution idea
I think it was resolved thanks to you. I set the tx power to low as you suggested and it is stable now.
One strange thing is that after using it well for several months, one day this problem appeared.
To guess the cause, I migrated the controller. Of course, there were no changes to the settings because the settings were exported and imported.
Thank you very much for your reply.
I am operating with the equipment configuration below in conjunction with the Omada controller, but recently, there is a problem with poor wifi quality.
ER707M2, SG3452(main), SG3428, EAP653 3EA, TP-LINK UnManaged 5Port PoE
I tried adjusting the channel and Tx values, multicast traffic, and checking the peculiarities of the connected clients for several days, but the problem was not solved.
I checked the switch CPU usage today and thought it was unusual, so I suspect that the wifi quality is poor because of the switch.
Please help me improve the wifi quality.
Please also refer to my previous posts.
